Instructions / Assembly

ManualsBrandsNorpole ManualsAppliances48 cu. ft. 2-Door Commercial Reach-In Freezer in Stainless Steel

COMMERCIAL REFRIGERATOR AND FREEZER

USER’S MANUAL

REACH-IN REFRIGERATOR AND FREEZER

PLEASE READ THE MANUAL THOROUGHLY PRIOR TO

EQUIPMENT SET-UP, OPERATION AND MAINTENANCE.

- 1 -

Refrigerator Model: NP1R, NP1R-G, NP2R, NP2R-G, NP3R

Freezer Model: NP1F, NP2F, NP3F

Summary of content (6 pages)

PAGE 1
COMMERCIAL REFRIGERATOR AND FREEZER USER’S MANUAL REACH-IN REFRIGERATOR AND FREEZER Refrigerator Model: Freezer Model: NP1R, NP1R-G, NP2R, NP2R-G, NP3R NP1F, NP2F, NP3F PLEASE READ THE MANUAL THOROUGHLY PRIOR TO EQUIPMENT SET-UP, OPERATION AND MAINTENANCE.
PAGE 2
INSTALLATION IMPORTANT!!! PLEASE READ BEFORE INSTALLATION ■ If the unit has recently been transported，please let unit stand still for a minimum of 24 hours before plugging it in. ■ Make sure that the unit drops down to desired temperature before loading the unit with product. ■ Make sure that there is proper ventilation around the unit in the area where it will operate. ■ Make sure all accessories are installed (i.e. shelves, shelf clips, casters) before plugging the unit in.
PAGE 3
with appropriate overcurrent protection. Please refer to the electrical requirements on the nameplate. Please make sure that your unit has its own dedicated outlet. Do not use an extension cord. SAFETY / WARNING Please pay close attention to the safety notices in this section. Disregarding these notices may lead to serious injury and/or damage to the unit. ATTENTION ■ To minimize shock and fire hazards, be sure not to overload outlet. Please designate one outlet for your unit.
PAGE 4
■ Do not attempt to alter or tamper with the electrical cord. ! REGULAR MAINTENANCE CLEANING THE CONDENSER COIL ■ For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. ■ We recommend cleaning the condenser coil and fins at least once per month. ■ Clean with a commercial condenser coil cleaner, available from any kitchen equipment retailer. Brush the condenser fins from top to bottom, not side to side.
PAGE 5
TROUBLE SHOOTING Before requesting any service on your unit, please check the following points. Please note that this guide serves only as a reference for solutions to common problems. SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION Compressor not running. Fuse blown or circuit breaker tripped. Replace fuse or reset circuit breaker. Plug in power cord. Set thermostat to lower temperature. Wait for defrost cycle to finish. Power cord unplugged. Thermostat set too high. Cabinet in defrost cycle.
PAGE 6
for long periods of time. (see above) Evaporator coil iced over. Cabinet is noisy. Loose part(s). Locate and tighten loose part(s). Ensure tubing is free from contact with other tubing or components. Tubing vibration.