Pizza Prep Table User’s Manual Model NP1R-PT / NP2R-PT / NP3R-PT READ THIS MANUAL CAREFULLY BEFORE USING YOUR Pizza prep table AND KEEP IT FOR FUTURE REFERENCE.
Product Registration Thank you for purchasing a Norpole® product. The first step to protect your new product is to complete the product registration on our website: www.mcappliance.com/register. The benefits of registering your product include the following: 1. Registering your product will allow us to contact you regarding a safety notification or product update. 2. Registering your product will allow for more efficient warranty service processing when warranty service is required. 3.
CONTENTS PRODUCT REGISTRATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 INSTALLATION INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 OPERATING INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CARE AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS WARNING: Hazards or unsafe practices which COULD result in severe personal injury or death. CAUTION: Hazards or unsafe practices which COULD result in minor personal injury or property damage. 1. Read all instructions before using the appliance. 2. CAUTION: Installation and maintenance should only be performed by certified professionals. Improper installation could result in serious harm or death and may void your warranty. 3.
Installation Instructions CAUTION: Read all instructions before installing. • Allow the unit to stand in place at least 24 hours after transporting or moving before plugging it in. • Make sure that the unit has reached the desired operating temperature before loading product into it. • Make sure that there is proper ventilation around the unit and in the space in which it will be used. • Verify that all accessories (shelf clips, shelves, casters, etc.
operation instructions CONTROL PANEL AND DISPLAY The control panel and display are located on the front left side of the unit, next to the main power switch. a. Control Panel and Display b. Main Power Switch c. Vent d. Front Left Caster e.
TURNING THE UNIT ON AND OFF Make sure that the main power switch next to the control panel is in the On position, then press and hold the Up-On/Off button ( ) for 3 seconds to turn on or off. SETTING THE TEMPERATURE To adjust the set temperature, follow the instructions below: 1. Press SET ( ) button for 1 second. The set temperature will start flashing after a few moments. 2. Use the UP ( ) or DOWN ( ) buttons increase or decrease the desired temperature setting.
care and Maintenance CLEANING THE CONDENSER COIL For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. It is recommended to clean the condenser coil and the fins at least once per month. Figure 4 To access the condenser, lift up on the cover with the control panel on the front of the unit and carefully pull it off the body of the unit. (See Figure 4.
Troubleshooting Before requesting any service on your unit, please check the following points. Symptom Possible Cause Compressor not running. Fuse blown or circuit breaker tripped. Replace fuse or reset circuit breaker. Power cord unplugged. Plug in power cord. Thermostat set too high. Set thermostat to lower temperature. Cabinet in defrost cycle. Wait for defrost cycle to finish. Excessive amount of warm product placed in unit. Allow adequate time for product to cool down.
LIMITED WARRANTY Norpole, Inc. warrants each new Prep Table to be free from defects in material and workmanship and agrees to remedy any such defect or to furnish a new part(s) (at the company’s option) for any part(s) of the unit that has failed during the warranty period. Parts and labor expenses are covered on this unit for a period of three years from the date of purchase. In addition, Norpole, Inc.
