Reach-In Freezer User’s Manual Model NP1F / NP2F / NP3F READ THIS MANUAL CAREFULLY BEFORE USING YOUR REACH-IN FREEZER AND KEEP IT FOR FUTURE REFERENCE.
Product Registration Thank you for purchasing a Norpole® product. The first step to protect your new product is to complete the product registration on our website: www.mcappliance.com/register. The benefits of registering your product include the following: 1. Registering your product will allow us to contact you regarding a safety notification or product update. 2. Registering your product will allow for more efficient warranty service processing when warranty service is required. 3.
CONTENTS PRODUCT REGISTRATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 INSTALLATION INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 OPERATING INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 CARE AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS WARNING: Hazards or unsafe practices which COULD result in severe personal injury or death. CAUTION: Hazards or unsafe practices which COULD result in minor personal injury or property damage. 1. Read all instructions before using the appliance. 2. CAUTION: Installation and maintenance should only be performed by certified professionals. Improper installation could result in serious harm or death and may void your warranty. 3.
Installation Instructions CAUTION: Read all instructions before installing • Allow the unit to stand in place at least 24 hours after transporting or moving before plugging it in. • Make sure that the unit has reached the desired operating temperature before loading product into it. • Make sure that there is proper ventilation around the unit and in the space in which it will be used. • Verify that all accessories (shelf clips, shelves, casters, etc.
operation instructions CONTROL PANEL AND DISPLAY a b c d e Figure 1 The control panel and display are located at the top, right side on the front of the unit, next to the main power switch. a. Door Lock b. Door c. Display d. Control Panel e. Main Power Switch Control Panel AND DISPLAY Figure 2 Figure 3 Prg mute Set Function aux def Description On On On when the compressor starts. Compressor Flashes when compressor is delayed by safety times.
NOTE: Not all features and functions are programmed on all models. NOTE: It is not recommended to change the default operating parameters for the temperature and defrost settings, or other advanced settings within the controller. If adjustments to these settings are needed, please contact customer service or a qualified service technician. TURNING THE UNIT ON AND OFF Use the main power switch at the top of the freezer next to the control panel to turn it on and off. SETTING THE TEMPERATURE 1.
care and Maintenance CLEANING THE CONDENSER COIL For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. It is recommended to clean the condenser coil and the fins at least once per month. Figure 4 Remove the screws holding the vent cover at the bottom of the unit in the front (see Figure 4) to access the condenser. Use a commercial condenser coil cleaner, available from any kitchen equipment retailer.
Troubleshooting Before requesting any service on your unit, please check the following points. Symptom Possible Cause Compressor not running. Fuse blown or circuit breaker tripped. Replace fuse or reset circuit breaker. Power cord unplugged. Plug in power cord. Thermostat set too high. Set thermostat to lower temperature. Cabinet in defrost cycle. Wait for defrost cycle to finish. Excessive amount of warm product placed in unit. Allow adequate time for product to cool down.
LIMITED WARRANTY Norpole, Inc. warrants each new Freezer to be free from defects in material and workmanship and agrees to remedy any such defect or to furnish a new part(s) (at the company’s option) for any part(s) of the unit that has failed during the warranty period. Parts and labor expenses are covered on this unit for a period of three years from the date of purchase. In addition, Norpole, Inc.
