Installation Manual

Note: Use this procedure if you need to change the system type or
settings after running the “initial setting procedure”
System Selection and Settings in the “Initial Settings” Screen
1
2
3
Preparation
Press the
button.
Operation Screen Display Description
Use the buttons “▼” to
navigate to “Initial settings.”
Press the
button to access
the initial settings menu.
Access Initial Settings Menu.
1) Turn Remote off.
2) Disconnect Power to all heaters and system
controller in multi-unit system.
3) Wait 10 seconds or more.
4) Reconnect power, DO NOT turn remote on.
Change System Type
1
2
3
In the initial settings menu select
“System type”.
The menu will have three options:
Standard, Recirc., and Tank Recirc.
1) Use the
buttons to navigate
to the appropriate system.
2) Press the
button to select
the desired system.
4
Once a system is selected, the
remote will display “Set Complete”.
* You may use the button to
return to the previous menu at any
time.
* You may use the
button to
return to the previous menu at any
time.
List of the Initial settings
System type The system type can be changed.
Sys settings The system settings can be changed.
[°F/gal]<
=
>[°C/L] The unit of temperature and ow rate on the screen can
be changed.
Adjust clock The gap of time per month on the clock can be adjusted.
Save backlight The power saving setting of the backlight on the screen
can be changed.
─11─