Install Instructions

- 9 -
• Do not connect electrical power to all heaters and system controller (do not turn ON the power supply) before all
electric wiring is completed. Otherwise, electric shock or failure of this product and the unit.
• Do not use a damaged (cut, torn, etc.) remote cord.
WARNING
6. Electrical Wiring
Consult a qualied electrician for the electrical work.
•
Electrostatic discharge can affect electronic components. Take precautions to prevent electrostatic discharges from
personnel or hand tools during the system controller installation and servicing to protect the product’s electronic control.
• Do not touch the electronics parts other than the wire connection terminal as it may cause a malfunction.
•
Be sure to tighten the screw to the wire connection terminal manually and do not use an electric drill or impact driver.
• Be sure to clamp the remote cord inside of this product according to instructions.
CAUTION
Connecting the Remote Cord to This Product
● Bottom wiring
Pull up the plastic cover and connect the remote cord to wire connection terminal. (The wire connection terminal
has no polarity.)
Then, return the plastic cover to its original position and hide the wire connection terminals.
Pull up the plastic cover for
connectting the remote cord.
Clamp the remote cord here.
Push the remote cord into this slot.
● Through the wall wiring
Pull up the plastic cover and connect the remote cord to wire connection terminal. (The wire connection terminal
has no polarity.)
Pass the remote cord through the hole and
connect it to the wire connection terminal.
Seal the slot with tape*.
* To avoid invasion of debris and/or bugs, seal the slot with tape or other sealant.
Connect the Y terminals to
wire connection terminal as shown.