Install Instructions

- 8 -
Open the front cover, pay attention to the vertical direction of this product, determine and mark the positions for the
three screws (two for the top and one for the bottom).
1. Drill holes for three screws.
If using drywall anchors, drill three holes with a diameter of 0.236" (6 mm)
and a depth of 0.98" to 1.18" (25 mm to 30 mm) and insert the anchors.
2. Tighten the screws.
3.
Take waterproof measures as necessary to prevent water from entering
from the screws.
4. The gap between anchor and wall will cause water invasion.
Mounting to the wall
Wiring in the wall
Drill a 0.315" (8mm) hole from the back of this product.
Aim at mark on the center of the "+" on back of this product.
Position of the hole for wirig the remote cord.
Make a φ1.1" (28mm) or
less hole to the wall.
Connect the remote cord to
the wire terminal block of the unit.
Make a hole with 0.315" diameter drill.
Caution: To prevent damaging the remote cord, remove any burrs from around the hole.
Make a φ1.1" (28mm) or less hole to the wall, align this product with the hole, and then x this product into place.
For outdoor installation, this wiring is not permitted.
Remote cord
Prohibited: