Install Instructions

- 11 -
7. Trial Operation
The installer should test operation of this product as described in below.
1. Connect electrical power to the unit. After 15 seconds all LEDs turn on for 3 seconds and then turn off.
If the LEDs do not turn on, this product is not receiving power.
Check this product and the unit are correctly connected with the remote cord.
2. If this product correctly communicates with the unit, the Unit LED turns on within about 4 minutes.
If this product does not communicate with the unit, the Unit LED will blink.
* Other than the Unit LED may blink, but this is normal.
The instructions on connecting this product to the wireless router is located in the Owner's Guide.