Owner's Guide
16
3rd step Pair the product to your smartphone
* From step 3, you will need to operate this product's button.
Check the Status LED is lit
(ON) or blinking. ( page 9)
Open the front cover. (
page 7)
Notication
Notication
If the Status LED is not lit, this product is not receiving power. Before using this
product, check the heater's power supply is on. This product has no power button.
This SSID and Key
of this product are written in the product information
sticker on the Plastic Cover. ( page 8).
The SSID and Key cannot be reissued, so be sure to write this information
on the cover page of this manual so that you can refer to it later on.
"AP" operation directions
Connection directions
1
Follow the directions on the screen and press
and hold the "AP" button on this product for
3 seconds or more. The AP mode starts and
all LEDs (Status, Unit, Router, and Server
LEDs) blink twice.
After the LEDs blink twice, tap "Next".
2
Close the NORITZ CONNECT App.
Tap the "Settings" on the Home Screen of
the smartphone, then open "Wireless LAN"
settings.
A list of available networks appears.
Choose the SSID of this product.
It should start with "NAW"(NAWXXXXXX).
A password is required. Enter the Key of this
product listed on plastic cover on the inside
of this product. After you have connected, go
back to the App screen, and tap "Next".
Setting up this product - 3