Install Instructions

42
2.Removethedecorativeframefromtheremote
controller. (The remote controller is inserted
inthedecorativeframe.)
3. Connect the remote controller wires to the
cordsuppliedwiththewaterheater.
*If theY-shaped terminal is not covered, the
exposed section may come into contact with
the mounting bracket resulting in improper
operationorfailure.
4. Securetheremotecontrollerwiresbywinding
themaroundthenotchesasshowninFig.1.
5.Attachtheremotecontrollertothemounting
 bracket. Insert the bottom of the remote
controllerintothegrooveatthebottomofthe
bracketandpushinthe2hooksontopofthe
remotecontrollercompletely.
*If it is difcult to attach, do not try to force it
as it may result in broken hooks. Check for
proper alignment in the groove or for loose
wiresobstructingtheremotecontroller.
*Donotinstallonthe
bracketbyforce,the
hooksmaybreak.
Hooks
Groove
Mounting
bracket
Mainremote
controllerbody
6. Securetheremoteusingthemachinescrews.
7. Attach the decorative frame which was
removedinthesecondstep.
 Pushthe 4 corners of the decorative frame
untilthereisaclick.
*Incomplete
installationmay
resultinfailures
suchasswitch
operationfailure.
Note: To remove the decorative frame after
installation of the remote controller and
the frame, pull the entire decorative
frameforwardwhilepressingthesections
indicated (where the fingers are) in the
gurebelow.
*Ifitdoesnotcomeoff,insertaathead
driverintothenotchatthebottomofthe
decorativeframeandslightlytwistitto
remove(duecautionisrequirednotto
scratchtheremotecontroller,decorative
frameorthewallindoingso).
Click Click
ClickClick
Putngersintothisgap.
Mainremote
controllerbody
Machinescrew
(accessorypart)
Rearsideoftheremotecontroller
Fig.1
Windingaroundthenotches
Passtheremote
controllerwires
throughthenotch.
SectionA
Insulatingcover
(Donotremove
thecover.)
Mountingbracket
Remotecontrollerwires
Forwiringinsidethewall
Forexposedwiring
Remotecontrollerwires
* Check the terminal is
coveredwithSectionA
  (    ) of the insulating
cover (clear,seeFig.1).
THIS SIDE UP
Remotecontrollercord
Forexposedwiring,usescissors
or shears to carefully cut “the
wiresinlettab”ofthedecorative
frame to create slot for wires
beforeattachingtowallmount.
Wiresinlettab
Decorativeframe
Remove the remote
controllerwhilepulling
the decorative frame
forward.
Decorativeframe
Mainremote
controllerbody
*Do not remove the remote controller wires
fromtheterminalblock,connectthesewiresto
theremotecontrollercord.
*Donotremovetheinsulatingcover(clear).
*Somemodicationsarerequiredontheframe
tocompletetheinstallation.Seenotebelow.