Install Instructions

41
Installation
1.Attachthemountingbrackettothewall.
 Thepartstobeusedvarydependingonthe
attachmentmethod.
*Neveruseelectricdrivers,impactdrivers
andsoforth.
 Tightening with excessive force may
result in deformation of the mounting
bracketand/orfailures.
Notes on the Installation Location
• Theremoteshouldbeinstalledinaneasily
accessiblelocation.
• Avoid installing in a place where water
or steam can come into contact with the
controller.
• Avoid locations where special chemical
agents (e.g., benzene, fatty and oily deter
gents)areused.
• Avoid outdoor installation, or installation in
anindoorlocationwhereitwillbeexposed
todirectsunlight.
Connection of Remote Controller Cord
WhiteConnector   ToRemotecontroller
Y-shapedterminals  ToWaterheater
(two-core)
* Conrmtheconnectionwiththelabelsat
bothendsoftheremotecontrollercord.
• A26'(8m)cordcanbepurchased
separately(Part#RC-CORD26).
• Theremotecontrollercordcanbeextened
upto300ft(90m).bysplicingthecordand
using18gaugewiretoextendthecordto
theappropriatelength.
(1)
(2)
(2)
(2)
(2)
(1)
Included Parts List
(Thevaluein()indicatesthequantity.)
Remote Controller
Mounting
bracket
Raisedcountersunk
headwoodscrew
Wallanchor
Raisedcountersunk
headscrew
(Forjunctionbox
installation)
Machine
screw
<Whenattachingtoajunctionbox>
•
Use the raised countersunk head screws to
attachthemountingbrackettothejunctionbox.
 (In this case, the wall anchor and raised
countersunkheadwoodscrewsarenotused.)
Top
Bottom
Junctionbox
Mountingbracket
(accessorypart)
Raised countersunk
headscrew
(accessorypart)
<Whenattachingtoawoodsurface>
•
Usetheraisedcountersunkheadwoodscrews
toattachthemountingbracket.
 (In this case, the wall anchor and raised
countersunkheadscrewsarenotused.)
Top
Bottom
Top
Bottom
<Whenattachingtoaconcretewallsurface>
•
Drilla φ1/4”(φ6mm) hole,approx. 1”(25mm)
indepth,andhammerinthewallanchor.
 Attach the mounting bracket using the raised
countersunkheadwoodscrews.
 (Inthiscase,raisedcountersunkheadscrewsarenotused.)
Mountingbracket
(accessorypart)
Mountingbracket
(accessorypart)
Wallanchor (accessorypart)
Raised countersunk
headwoodscrew
(accessorypart)
Raised countersunk
headwoodscrew
(accessorypart)
Confirm the orientation
ofthemountingbracket.
Confirm the orientation
ofthemountingbracket.
Confirm the orientation of the
mountingbracketiscorrect.