Use and Care Manual

24
The screen returns to the “Recirc Menu”.
10. Press the ENTER button to complete the time
setting.
3. Press the ENTER button.
2. Press the ENTER button.
2. Press the ENTER button.
3. Select the time period following the procedures
in steps 6 to 9 on page 23.
3. Adjust the time period following the procedures
in steps 6 to 9 on page 23.
“Recirc timer” and “Recirc timer on”
are alternately displayed on the menu
(approximately 10 seconds)
(Example of home screen
when the Power button is turned ON)
(All settings are cleared.)
Displayed
• The timer will not activate without pressing
the ENTER button.
• If the time is not set, the time setting screen is
displayed (See page 11).
• Until the timer is deactivated, the recirculation
system will operate daily at the set “Start” and
“End” times.
• If the Power button is ON, the screen returns
to the home screen in approximately 10
seconds.
• If the timer is deactivated during a
recirculation time period, recirculation
will continue until it is stopped using the
procedure shown on page 22.
• You can set multiple operation time periods.
Add Additional Time Periods
Cancel the Recirculation System
Operation Timer
Reset All Time Periods
1. After step 9 on page 23, select “Add” using the
/ buttons.
1. Carry out steps 1 to 5 on page 23.
2. Select “Cancelled” using the / buttons.
1. After step 9 on page 23, select “Reset” using the
/ buttons.
Setting the Recirculation System Operation Timer