Specifications

TRIGGER ADJUSTMENT

English

SIGHT SCOPE

The trigger of some Norica rifles is supplied with an adjusting screw for second

stage length. Adjustment is carried out as follow: for REDUCTION- rotate

screw clockwise; for INCREASE – rotate screw counter - clockwise.

Our rifles leave the factory duly set for a 10-metre shooting distance range. When

the shooter wishes to use other distances he must keep the sight correctly in the

following ways:

•

To correct a gun shooting low, turn the

rearsight elevation screw anticlockwise to

raise the leaf.

•

To correct a gun shooting high, turn

the rearsight elevation screw clockwise to

lower the leaf.

•

To correct a gun shooting to the right,

turn the rearsight windage screw anticlock-

wise to move the blade to the left.

•

To correct a gun shooting to the left,

turn the rearsight windage screw clockwise

to move the blade to the right.

ADJUSTING THE SCOPE

Setting and adjustment of the sight 4x32 and its fitting on the tube:

1. Loose the screws A.

2. Place it on the rails of the barrel till it catches the small metal plate.

3. Tighten the screws A.

4. Range through the roller B and the adjusting screws: horizontal D and verti-

cal F.

5. Release the rifle scope from the tube and tighten the screws C in order to

completely fix the sight and later carry out the second and third steps.

6. In case of wishing to adjust the shot again, use only the adjusting screws D

and F.