Manual
3-24 Operating Characteristics
LimitTransition
Event
LimitTransition
Event
LimitTransition
Event
UPPERDB
LOWERDB
GWGEM automatically handles Limits Monitoring. Configuration data ( limits,
CEIDs, etc. ) must be set in the GCD file ( [ RefGWGEMUser ] ) p 165 ‘Limits
Monitoring’ ).
3.4.7.1 Event Signaling
For any event that exists on the equipment, the event message will be sent to the
Host only if the reporting for that particular event has been enabled. In this "EVENT
SIGNALING" section, assume that the Host has enabled the proper reporting so that
these events will be sent to the Host.
After the Host sets UPPERDB and LOWERDB values for a particular limit, the
GES-1993 will send an event message when a transition occurs across these
boundaries. The procedure for reporting is explained in the following chart and state
chart diagram:
Figure 3-5 Limits Events Signaling