Manual

Operating Characteristics 3-19
3.3.3 GES Process State Transitions
Table 3-8 Process State Transitions
# From Trigger To Description
1 Unknown Power-Up Idle At power-up, the Equipment defaults to
the IDLE state.
2 Idle Run Command Running
Either the Host or Operator issues a run
command. This command can be
issued by a remote command from the
Host or by local Operator.
3 Running Pause Command Paused
Either the Host or Operator issues a
pause command. This command can
be issued by a remote command from
the Host or by local Operator.
4 Paused Unpause
Command
Running
Either the Host or Operator issues a
unpause command. This command can
be issued by a remote command from
the Host or by local Operator.
5 Running Stop Command Idle
Either the Host or Operator issues a
stop command. This command can be
issued by a remote command from the
Host or by Local Operator. This
command will stop processing after the
current board has completed.
6 Running Error Occurrence Error
An error has occurred on the
Equipment.
7 Error Operator Error
Acknowledge
Idle
Once the operator has acknowledged
the error, the equipment will transition
to the Idle state.
8 Running Abort Command Aborting
Either the Host or Operator issues an
abort command. This command can be
issued by a remote command from the
Host or by Local Operator.
9 Aborting Machine stopped Idle
Once the machine has halted, the
equipment will transition to the Idle
state.
10 Paused Stop Command Idle
Either the Host or Operator issues a
stop command. This command can be
issued by a remote command from the
Host or by Local Operator.