Manual

3-16 Operating Characteristics
3.3.1.1 E10 STATE TRANSITIONS
Table 3-7 E10 State Transitions
# From Trigger To Description
1 Unknown Power-Up Non-
Scheduled
Time
Upon Power-Up, the Equipment defaults
to this state.
2 Unknown Operator
Request
Conditional The Operator changes states from the
previous state to the new state. The
conditional depends on the Operator's
intentions.
3 Non-
Productive
Operator
Request
Non-
Productive
4 Standby Processing
of material
begins.
Productive Equipment is processing material.
5 Productive Operator
Request
Non-
Productive
The Operator changes states from
Productive to a new Non-Productive state.
Transition will be made according to
conditional transition #2.
3.3.1.2 E10 STATES
3.3.1.2.1 Non-Productive/Non-Scheduled Time
The Equipment is not scheduled to be used in production. An Equipment operator
can put the GES-1993 into this state at any time.
3.3.1.2.2 Non-Productive/Unscheduled Downtime
The GES-1993 has been scheduled to be used in production, but is unable to be used
because of unforeseen events. Possible reasons for transitions into this state include:
1) maintenance delay; 2) repair; 3) replacement of disposable; 4) bad input (bad
boards, etc.); or 5) facilities related downtime.
3.3.1.2.3 Non-Productive/Scheduled Downtime
The GES-1993 has been scheduled to be out of production so that maintenance can
be performed.