Manual

Introduction 1-17
The operator will need to correct the alarm condition and guide the machine through
the Paused state to the Idle State. When the machine is prepared to enter the Running
state again, the operator can open the GEM control screen and send the Proceed
event message to the Host to resume REMOTE operations.
The Host may poll the Equipment to receive lists of enabled or existing alarms.
When the Host sends a List Alarm Data message (S5F6) the Equipment replies with
a list of the current active alarms. The Host may receive a list of the currently
enabled alarms with the List Enabled Alarms Request (S5F7).
1.9.6.2 Remote Control Operations
Both the Host and the operator are allowed to request runtime control of FmNT from
each other. When the control state is Local, only the operator has the ability to
command FmNT, and Host run commands are rejected. Conversely, when the Host
has control of FmNT, the operator is limited to requesting FmNT status displays and
Help screens. The operator can stop, abort, or pause the process from the Run
Window. Host will receive an event if the operator presses any of the buttons from
the Run Window. Refer to appendix B for the list of these events.
Both the operator and the Host may request that control be turned over to the
requester. Each change in the control state machine generates a notification event to
the Host.
Remote run commands consist of START, STOP, PAUSE, RESUME, LOCAL,
REMOTE, and ABORT.
START
This command is successful when the Control State is OnLine - REMOTE , the
board is in the Dispensing position, the machine is configured for a run, and the
process program has been selected. This event begins the continuous processing of
substrate trays. Processing can be interrupted by STOP, PAUSE, and ABORT
commands. The operator can also initiate PAUSE, and STOP commands from Run
Window.
STOP
This command is successful when the Control State is OnLine - REMOTE, and the
Process State is Running. It causes a halt in dispensing following completion of the
current substrate cycle. The Process State changes to Idle when this command is
delivered. The process program is terminated by this command. (KAM_TODO)
Further processing of the substrate tray is not possible after completing this
command.