Manual

Introduction 1-11
1. Equipment Constant "CONFIGALARMS" (VID 18) selects the message the
Equipment will send for Alarm Reports. "ConfigAlarms" may be 0, 1, or 2,
selection S5F1, S5F71, or S5F73, respectively.
2. Equipment Constant "CONFIGCONNECT" (VID 19) selects the message the
Equipment will send for Connect Request. "ConfigConnect" may be 0, 1, or 2,
selecting S1F1, S1F65, or S1F13, respectively.
3. Equipment Constant "CONFIGEVENTS" (VID 20) selects which message the
Equipment will send for Event Reports. If "ConfigEvents" is 0, the Equipment
will send S6F9 for normal (unannotated) event reports or S6F3 for annotated
event reports. If "ConfigEvents" is 1, the Equipment will send S6F11 for normal
event reports or S6F13 for annotated event reports.
4. Equipment Constant "RPTYPE" (VID 16) selects whether the Equipment will
send "normal" event reports (S6F9 or S6F11) or annotated event reports (S6F3 or
S6F13).
RpType="False". Equipment will send "normal" event reports.
RpType="True". Equipment will send annotated event reports.
Table 1-4 GemRPType
GemConfigEvents = 0 GemConfigEvents = 1
GemRPType = FALSE
S6F9 S6F11
GemRPType = TRUE
S6F3 S6F13
5. For a non-GEM Host, build appropriate Report Definitions, Links, and Enables
(S2F33, S2F35, S2F37) so that S6F9 or S6F3 event reports contain the desired
data. See "How to Configure", below.
6. Equipment Constant "WBITS5" (VID 21) selects whether Stream 5 primary
message (S5F1, S5F71, and S5F73) sent by the Equipment will have the W-bit
set to "0" or "1".
7. Equipment Constant "WBITS6" (VID 22) selects whether Stream 6 primary
messages (S6F1, S6F3, S6F9, S6F11, and S6F13) sent by the Equipment will
have the W-bit set to "0" or "1".
8. Equipment Constant "WBITS10" (VID 23) selects whether Stream 10 primary
message S10F1 sent by the Equipment will have the W-bit set to "0" or "1".
9. Equipment Constant "CONFIGSPOOL" (VID 66) configures whether the
Equipment will transition to "Spool Active" state when a RTY error occurs.