Manual

10-2 Appendix B
CEID Name Description
20 EqConstChange Sent to the Host when the operator changes an
Equipment Constant.
21 S10Ack Sent to acknowledge the reception of a Host text
message.
22 GemEquipmentOFFLINE Sent when Control State changes to Off-Line.
23 GemSpoolingActivated Sent when Equipment attempts to send a primary
message to the Host and gets a transmit failure while
Spooling is enabled.
24 GemSpoolingDeactivated Sent after the entire spool file has been read by the
Host.
25 GemSpoolTransmitFailure Send if a transmission failure occurs during the
period in which the Host is reading the Spooling file.
Board handling
2001 BoardAtDispenseLoc1 The board is at the dispensing location for
Conveyor 1 and ready for dispensing.
2002 DispensingDone1 Dispensing is completed for Conveyor 1. The
board is ready to leave the dispensing location.
2003 BoardAtDispenseLoc2 The board is at the dispensing location for
Conveyor 2 and ready for dispensing.
2004 DispensingDone2 Dispensing is completed for Conveyor 2. The
board is ready to leave the dispensing location.
File handling
3001 NewProgramLoaded A new program is loaded.
3002 NewFluidFileLoaded1 A new fluid parameter file for Valve 1 is loaded.
3003 NewHeaterFileLoaded A new heater parameter file is loaded.
3004 FluidParametersModified1 The fluid parameters for Valve 1 have been
changed by an operator.
3005 FluidParametersSaved1 The fluid parameters for Valve 1 have been saved
onto the local mass storage.
3008 ConveyorCodeDownloaded1 A new conveyor control code has been
downloaded into the Conveyor 1 controller.
3009 NewFluidFileLoaded2 A new fluid parameter file for Valve 2 is loaded by
an operator.
3010 FluidParametersModified2 The fluid parameters for Valve 2 have been
changed by an operator.
3011 FluidParametersSaved2 The fluid parameters for Valve 2 have been saved
onto the local mass storage.