Owner's manual

3-26 Operating Characteristics
The following commands may be sent by the Host to the Equipment:
START
This command starts processing on the Equipment assuming all proper initialization has taken place and
material is present.
S2F41 [W]
<L [2]
<A ‘ START’ >
<L>
> .
STOP
This command will stop the processing of material at the Equipment. Boards currently in process will be
completed, but no new boards will be loaded.
S2F41 [W]
<L [2]
<A ‘ STOP’ >
<L>
> .
PAUSE
The PAUSE command will cause the Equipment to complete the current instruction in process, but not to
start the next instruction until the RESUME command has been given.
S2F41 [W]
<L [2]
<A ‘ PAUSE’ >
<L>
> .