Owner's manual

F-144 Appendix F - Variables Grouped by Fluidmove Activity
Configuration Editor
With normal operation, the SECS/GEM host will control turning fiducials ON or OFF. However, if the SECS/GEM host is not available and has left the
tool in an undesirable state (ie, has turned fiducials OFF but this state is no longer desired), the workpiece and pattern control variables can be changed
manually via the configuration editor.
1. In the left window, select the Configuration Group “Gem Manager”.
2. In the right window, “Find Pattern Fids” controls pattern fiducial finding. Set this parameter to “ON” to allow pattern fiducials to be found
(normal running state) or “OFF” to turn off fiducial finding for those patterns with SECS/GEM control enabled.
3. “Find Workpiece Fids” in the right window controls workpiece fiducial finding. Set this parameter to “ON” to allow workpiece fiducials to be
found (normal running state) or “OFF” to turn off workpiece fiducial finding.
Figure F.62-4 Editing Configuration Files