Owner's manual

F-78 Appendix F - Variables Grouped by Fluidmove Activity
Table F.29-2 DJ Offset Calibration – Equipment Constants
Variable Name ID
Storage
Type
SECS
Type
CEID Description
c_DJOffsetInitialDotXY_V1 6538 A40 EC 3749 DJ Offset initial dot XY location Valve 1.
c_DJOffsetCalEndPtXY_V1 6579 A40 EC 3749 DJ Offset XY end pt location for Valve 1.
c_DJOffsetHeadSpeed_V1 6539 A40 EC 3749 DJ Offset dispense speed Valve 1.
c_DJOffsetDispenseGap_V1 6540 A40 EC 3749 DJ Offset dispense gap Valve 1.
c_DJOffset_V1 6541 A40 EC 3749 DJ Offset value for Valve 1.
c_DJOffsetInitialDotXY_V2 6574 A40 EC 3749 DJ Offset initial dot XY location valve 2.
c_DJOffsetHeadSpeed_V2 6575 A40 EC 3749 DJ Offset dispense speed valve 2
c_DJOffsetDispenseGap_V2 6576 A40 EC 3749 DJ Offset dispense gap valve 2.
c_DJOffset_V2 6573 A40 EC 3749 DJ Offset value for valve 2.
c_DJOffsetUseDotFinder 6577 I4 EC --- DJ Offset calibration Use Dot Finder option.
c_DJOffsetRunUnassisted 6578 Boolean EC --- DJ Offset calibration Run Unassisted option.
Usage Scenario
The SECS/GEM host starts the DJ Offset Calibration setup process by sending the remote command DJ OFFSET CALIBRATION to the dispensing tool.
After the offset process is finished, collection event 3749 is triggered to notify the host.
The DJ Offset Calibration must be done manually the first time to setup parameters for initial dot location, dispense speed, dispense gap, and dot finder
calibration. After the initial setup is completed, the following options must be checked to run this feature without operator interaction:
• Use Dot Finder
• Run calibration at last taught position with no further operator interaction