Owner's manual

Machine Variable Definitions 6-7
Table 6-2 Data Variables (continued)
Variable Name ID
Storage
Type
Description
FlowRateMax2 405 F8
The maximum flow rate in mg./sec. allowed during this
run for Valve 2.
FlowRateMin1 401 F8
The minimum flow rate in mg./sec. allowed during this
run for Valve 1.
FlowRateMin2 404 F8
The minimum flow rate in mg./sec. allowed during this
run for Valve 2.
GEMLIMITSVID 57 U4
Contains the VID of the variable whose value crossed
defined limits.
NumFailedBoards 107 U4
The number of boards failed since PwrUp or since the
Process State entered the Running state.
PPCHANGENAME 40 A[0..8]
The PPID of the Process Program most recently
changed.
PPCHANGESTATUS 41 U1
The last action performed on the Process Program.
1 – Created
2 – Changed
3 - Deleted
ScaleMeasurement1 406 F8
The actual value read from the scale during a Flow Rate
Verification Procedure when Valve 1 is being used.
ScaleMeasurement2 407 F8
The actual value read from the scale during a Flow Rate
Verification Procedure when Valve 2 is being used.
TEMPHTR1CHAN1 –
TEMPHTR1CHAN17
801 to
817
F8
Heater 1 temperatures for channels 1-17 respectively
(DV 801 = channel 1, DV 802 = channel 2, etc.).
The units are in degrees. No other information is
supplied such as the unit of degrees (Centigrade or
Fahrenheit) or what device the channel is mapped to (ie,
pre-dispense station, needle heater, etc.). A value of
negative one (-1) indicates the channel is not monitored
or not turned on.
Note: These variables are only updated between boats
and only when monitored by “Verify Temperature Before
Initial Dispense”.
TEMPHTR2CHAN1 –
TEMPHTR2CHAN17
818 to
834
F8
Identical to Data Variables 801-817 except that they
refer to Heater 2 channels 1-17, respectively (DV 818 =
channel 1 of heater 2, DV 819 = channel 2 of heater 2
etc.)
TEMPHTR3CHAN1 –
TEMPHTR3CHAN17
835 to
851
F8
Identical to Data Variables 801-817 except that they
refer to Heater 3 channels 1-17, respectively (DV 835 =
channel 1 of heater 3, DV 836 = channel 2 of heater 3
etc.)