Owner's manual

6-6 Machine Variable Definitions
Table 6-2 Data Variables (continued)
Variable Name ID
Storage
Type
Description
DWVMEASUREDRANGE
415 F8
Dispense Weight Verification Measured Range: If range
limit checking is enabled, this variable will be compared
against DMVTARGETRANGE and used as one of the
conditions for a pass/fail result. If limit checking is not
enabled, this value will still be valid but not used in the
pass/fail decision.
If the routine fails to due limit checking or is interrupted
before it completes, the variable will contain “-1”.
Valid only after collection event
“DispenseWeightComplete” occurs.
DWVMEASUREDAVG 416 F8
Dispense Weight Verification Average: average weight
of all dispenses after the dispense weight verification
completes or “-1” if the routine fails or is interrupted
before it completes.
Valid only after collection event
“DispenseWeightComplete” occurs.
ECIDCHANGE 46 U4 The ID of the last event to be reported to the Host.
FluidState1 306 A[10]
Fluid level of syringe on Valve 1as reported by the low
fluid sensor or fluid level monitoring software. This value
is updated twice per board. Once when the board is
loaded and ready for dispensing and again when
dispensing is complete on that board. Possible values
are:
“FULL” – Fluid level is full.
“LOW” – Fluid level has reached the low level.
“EMPTY” – Fluid level is close to empty. This value is
possible only with the two position hardware sensor.
“NONE” – Fluid sensing sensors do not exist or software
monitoring has not been turned on.
“ERROR” – Error when using the two position hardware
sensor. Signals indicate empty but not low.
FluidState2 307 A[10] Same as FluidState1, but for Valve 2.
FlowRate1 400 F8
The most current fluid flow rate in mg. per second for
Valve 1.
FlowRate2 403 F8
The most current fluid flow rate in mg. per second for
Valve 2.
FlowRateMax1 402 F8
The maximum flow rate in mg./sec. allowed during this
run for Valve 1.