Owner's manual

SECS Scenarios 5-7
5.2.11 Host Requests Report by RPTID
Table 5-16 SECS Messages Host Requests Report by RPTID
Step SECS Message Description
1 H -> E S6F19 W
Request Report. The Host requests a report for the specified
RPTID.
2 H <- E S6F20 The Equipment sends the report.
5.2.12 Host Requests Annotated Report by RPTID
Table 5-17 SECS Messages Host Requests Annotated Report by RPTID
Step SECS Message Description
1 H -> E S6F21 W
Request Annotated Report. The Host requests an annotated
report for the specified RPTID.
2 H <- E S6F22 The Equipment sends the annotated report.
5.2.13 Are You There
Table 5-18 SECS Messages Are You There
Step SECS Message Description
1 H -> E S1F1 W Are You There. The Host sends this simple message.
2 H <- E S1F2 The Equipment reports its MDLN and SOFTREV.
5.2.14 Host Reads Equipment Constants
Table 5-19 SECS Messages Host Reads Equipment Constants
Step SECS Message Description
1 H -> E S2F13 W Host requests the values of one or more equipment constants.
2 H <- E S2F14
The Equipment responds with the values of the requested
equipment constants.
5.2.15 Host Sets Equipment Constants
Table 5-20 SECS Messages Host Sets Equipment Constants
Step SECS Message Description
1 H -> E S2F15 W Host sends new values for one or more equipment constants.
2 H <- E S2F16
If all new values are valid, the Equipment saves the new values
and sends this message with an acknowledge code of “0”. If one or
more new values are not valid, no equipment constants are
changed and the acknowledge code in this message is non-zero.