Owner's manual

SECS Message Detail 4-19
The Host specifies one or more Report IDs, and defines which Variables should be included in each
report.
If S2F33 is multi-block, the Host may optionally send the S2F39/S2F40 Inquire/Grant Transaction before
sending S2F33, but this Equipment does not require it.
The Equipment ignores DATAID.
If the Equipment already contains existing Report Definitions, then this message can be used to
download additional definitions for RPTIDs not yet defined. The Host cannot download a new Report
Definition for a RPTID for which a Report Definition already exists in the Equipment. Instead, to change
a Report Definition the Host must first delete the old Report Definition and then send a new Report
Definition for that RPTID.
The Host can delete selected report definitions and associated links in the Equipment by using the
following specifications in S2F33:
...
<L [2]
<U4 RPTID> * Report ID to delete
<L>
...
The Host can delete all report definitions and associated links in the Equipment by using the following
special format:
S2F33 W * H->E
<L [2]
<U4 DATAID> * DATAID
<L>
> .
4.2.33 S2F34 - Define Report Acknowledge
S2F34 * H<-E
<B [1] DRACK> . * DRACK - Acknowledge Code
Normally, DRACK is zero. Any non-zero DRACK indicates the Equipment has rejected the entire S2F33
message.
Table 4-8 DRACK Values
DRACK Description
0x00 OK.
0x02 Denied. Invalid format.
0x03 Denied. At least one RPTID already defined.
0x04 Denied. At least one VID does not exist.