Manual

PAUSE
The PAUSE command will cause the Equipment to complete the current instruction in process, but not to
start the next instruction until the RESUME command has been given.
S2F41 [W]
<L [2]
<A ‘PAUSE’>
<L>
> .
RESUME
After a PAUSE command has been given, the RESUME command will continue to process the existing
board according to the recipe.
S2F41 [W]
<L [2]
<A ‘RESUME’>
<L>
> .
LOCAL
While the Equipment is in Remote state, the Host can put the Equipment into Local state by sending the
LOCAL command.
S2F41 [W]
<L [2]
<A ‘LOCAL’>
<L>
> .
ABORT
The Host can abort processing at the next safe stopping point by sending the ABORT command with the
AbortLevel parameter as follows:
S2F41 [W]
<L [2]
<A ‘ABORT’>
<L
<L
<A ‘AbortLevel’> *CPNAME
<U1 1> *CPVAL
>
>
> .
Operating Characteristics 3-31