Owner's manual

System Configuration and Setup 4-37
4. Click on the Configuration tab and select the desired options. See Figure 4-37 for
descriptions.
5. Click
Apply and go to the next tab, or if finished, click on OK.
Command Description
Enable E10
Equipment States
If checked, E10 Equipment States is enabled. FmXP must be restarted when
changing this selection.
Powerup State…
Determines which state FmXP will boot up in if not powered down correctly
(power fails or system crashes) and the current state was STANDBY or
PRODUCTIVE.
The downtime is always logged as UNSCHEDULED DOWNTIME. FmXP
reboots into the UNSCHEDULED DOWNTIME or STANDBY state,
depending on the selection made.
Select action…
Determines what the software should do if the operator is attempting to run
production, but a state other than PRODUCTIVE is locked.
The software either warns the operator that it cannot transition to
PRODUCTIVE state and continue (without changing states) or automatically
unlocks the state and transitions to the PRODUCTIVE state before
continuing, depending on the selection made.
Powerdown Time
Interval
The time between E10 state “heartbeats”. A heartbeat is a time stamp that is
written to a file on disk every specified number of seconds. The heartbeat is
used to determine how long a system has been powered down after a power
failure or system crash. The resolution of the interval is 60 to 3600 seconds.
Figure 4-37 E10 Equipment States Window – Configuration Tab