Owner's manual

4-36 System Configuration and Setup
4.3.10.4.4 E10 Option Setup
 NOTE The E10 Equipment States option must be enabled before proceeding with this procedure.
1. In the Main Window, select
Configuration > Setup Runtime Preferences >
E10 Equipment States
.
 The E10 Equipment States window opens to the Change/Lock Status tab.
See Figure 4-36.
2. Select the desired options.
3. Click
Apply and go to the next tab, or if finished click on OK.
Command Description
Current State Displays the current E10 Equipment State name.
Current Substate Displays the current state code that corresponds to the current state.
State Locked
If checked, the current state is locked. A lock icon appears on the E10 status
bar. The state does not change until it is unlocked by the operator.
Change State
If checked, lets you manually change the equipment state. Click on the drop-
down arrow and select the desired basic state from the list.
To enter a substate, enable the “Change State” check box and type the
substate code directly into the list box.
If a state is changed and not locked, it may transition to a new state when a
transition point is encountered.
Figure 4-36 E10 Equipment States Window – Change/Lock State Tab