Owner's manual

4-26 System Configuration and Setup
To Teach an LMO – Workpiece Origin (WPO):
1. Click on the Workpiece Origin tab and select Enable Local Machine Workpiece Origin.
Figure 4-19 Local Machine Offsets – Workpiece Origin
2. Click on the Edit button to create the new WPO offset location.
a. To use an already created workpiece origin offset select it from the C
urrent Workpiece
Origin
drop-down list and click the OK button.
b. The
Realign button is used to reteach a current local machine origin location.
Figure 4-20 Select Workpiece Origin
c. Click the New button to create the new WPO offset or the Modify / Delete buttons as
needed.
d. Type the name of the new WPO offset location.
 It is recommended that you use the name of the “.fmw” program associated with the
WPO offset so it is easier to pick from the list of created WPO offsets when you
need to match it