Owner's manual

4-10 System Configuration and Setup
Group/Feature Group/Feature
Tools Diagnostics Production Run Setup
Height Sense Test Run Setup – Wet/Dry Run
Multi-Point Height Sense Test Run Setup – Use Conveyor
Gear Test Run Setup – Conveyor Modes
Upload Valve History Run Setup – Set Number of Runs
Upload Needle Heater History Run Setup – Number of Runs
Upload Substrate Heater History Scanner Tab
Fan Test Ignore Flowrate Deviation Error
Deadband Skip-Button Access to Time Dialogs
Hubble
Syringe Data Dialog
Repeatability Software Low Fluid Management
Multi-Point Moves
Pattern Library Access
Serpentine Motion Add/Delete/Modify Library Patterns
Communication Test
Program Instructions
Jog Dialog
Height Sense Limit Retry
Select Conveyor 1 Height Sense Limit Ignore
Select Conveyor 2
DJ Cycle Limit Dialog
Change Conveyor Width Override
Dispense Weight Verification Dialog
Clear Conveyor
Target Weight End Run
Time Between Dispenses
DJ Valve Settings
Number of Dispenses Reset DJ Cycle count
Maximum Limit Change DJ Cycle Limit
Minimum Limit Enable DJ Cycle Limit checking
Max Range Limit
Heater File Verify Dialog
Method Selection Reload Heater File
Block Production Run with Current Settings
Apply Limit Checking
Dual Dispense Group
Valve On Time Adjustment Tolerance
Purge Before Running Verification
Valve Auto Bias Dialog
Valve Auto Bias
Set Valve Auto Bias