Owner's manual

Tour of Fluidmove 3-19
3.4.5.2 Process Toolbar
The Process Toolbar, located along the top of the Programming Window, contains some of the frequently
items from the menu bar. The commands associated with each icon on the Process Toolbar are identified
and described in Figure 3-14. See Appendix A for a detailed description of Process Toolbar commands.
 NOTE As you move the cursor over a button, notice that a “tip” appears below the
button, explaining its function. When you move it away, the tip disappears.
If a button is grayed-out, the command is not available at this point in the
programming session.
The Wet/Dry Run Mode and Video Display On/Off buttons toggle between the
two modes.

*The program will stop after completing the current board.
Figure 3-14 Process Toolbar
Cut Program Lines
Copy Program
Lines
Paste Program
Lines
Run a Program Pause Run at End
of Next Command
Stop Run at End
of Program*
Run Program in
Steps
Abort Run
Video Display On/Off
Purge Valve
Measure Flow
Rate
Create a New
Program File
Open a New
Program File
Save Current
Program
Print Current
Program
Load a Board
Unload a Board
Wet or Dry Run
Mode
Move Dispensing Head
to Home Position
Access Jog
Controls
Access
Help
Return to
Main Menu