Owner's manual

A-4 Appendix A - Programming Menu Detail
• Select Module ID Pattern - This applies only when the RFID feature is enabled. Once a pattern
is created, it must be selected as the Module Definition Pattern.
• Select Program Key Pattern
- Selecting this item displays the "Select Program Key Pattern"
dialog. User will select a pattern in the dropdown list that will be used as the key pattern for
dual valve simultaneous setup operation. The dual valve motors will adjust Valve 2 only for
the key pattern during operation. This selection only is enabled with Dual Valve operation
with TMIC motion control.
• Set Dual Dispense MFC Tolerance
- Allows the user to specify the maximum allowed
difference in flowrates (mg/sec) on dual needle valve systems.
• Set Default Lighting
- Sets lighting levels when Fluidmove program is idling.
• Set Map Coordinate System
- This is for strip mapping feature. It indicates the Map XY
coordinate system used in the current Fluidmove program.
• Set Map File Control
- Enables strip mapping features that request a map file to control
dispensing behavior.
• Set Production Conveyor Run Mode
- Enable this feature by setting Fmconfig.ini - [Conveyor
Manager] “Select Conveyor Disable Mode" to ON. Opens a dialog to select the Production
Conveyor Run Mode and save it in the FMW program file. When an FMW program is loaded
with Production Conveyor Run Mode set, the conveyor run mode is set to this value,
overriding the conveyor run mode stored in the fmconfig.ini file.
• Set FluxJet Setup Parameters
- Allows editing of special parameters to setup the FluxJet valve.
• Set Workpiece Fiducial Option
- Allows the user to select how Fluidmove should react when
fiducials are not found (Skip, Abort, Prompt).
• Set Barcode Disable Option
- Allows user to disable the barcode feature depending on the
program.