Owner's manual

8-4 Running Production
2. Make sure Non-Scripted Setup Dialogs is selected.
3. Click
OK.
4. Select
Run a Program from the Main Window.
 The Production Window opens.
5. Click on
Setup.
6. Click on
Prompted Setup.
 The Prompted Setup Dialog box opens. See Figure 8-3.
Figure 8-3 Original Prompted Setup
7. Make sure the work area is clear of any obstacles so the Dispensing Head does not collide
with anything when it moves.
8. Click on
Next.
9. You will be prompted to check the purge cup and scale cup.
10. When you have finished checking the purge and scale cups, click
Next.
11. You will then be prompted to change the purge boot, if necessary.
12. Change the purge boot if necessary and click
Next.
13. You will then be prompted to install a new needle, shield, etc.
14. Install a new needle, shield, etc., if necessary and click
Next.