Owner's manual

7-70 Advanced Programming
Table 7-4 Weight Calibration - Setup Tab Description
Name Description
Parameter Limits
Fluid Pressure
Enter minimum, maximum, and initial fluid pressure for calibration
routine.
Valve On Time
Enter minimum, maximum, and initial valve on time for calibration
routine.
Valve Off Time
Enter minimum, maximum, and initial valve off time for calibration
routine.
Shots/LED Enter minimum and maximum number of shots (dots).
Setup
Initial Number of Shots Enter initial number of shots (dots) used during the calibration routine.
Special Active Air Pressure Active air pressure used only during calibration and validation.
Line Type NOT USED.
Input Dot Type
Enter input dot type. Used to begin calibration routine if program uses
dots.
Output Dot Type
Select output dot type(s) that correspond to those used in program for
LED (cell). Total number of dots calculated from the calibration routine
is distributed among the output dot types selected.
Production Parameters
TDS Weight to Dispense
Quick Dispense Weight. If not within the tolerance weight, the
calibration will continue.
EOS Activation Weight Advanced Settings. Contact Nordson ASYMTEK.
EOS dP/dW Advanced Settings. Contact Nordson ASYMTEK.
Edit Dot Opens the Edit Dot Parameters window.
Edit Line Opens the Edit Line Parameters window.