Owner's manual

Advanced Programming 7-67
7.12.2 Weight Calibration Window
 NOTE Advanced CPJ + must be enabled to access this window.
7.12.2.1 Calibration Tab
The Calibration tab displays weight calibration and validation parameters. You can also purge the active
nozzle from this window.
To purge active nozzle from the Weight Calibration Window:
1. Select
Teach a Program from the FmXP Main Window.
 The Programming Window opens.
2. Click on the
Measure Flow Rate icon on the toolbar.
 The Weight Calibration Window opens (Figure 7-54).
3. Verify weight calibration parameters limits and production parameters.
See 7.12.2.2 Setup Tab.
4. Click on
Purge Active Air.
Figure 7-54 Advanced CPJ + Weight Calibration – Calibration Tab
Table 7-3 contains a description of options on the Weight Calibration - Calibration Tab.