Owner's manual

Advanced Programming 7-65
3. In the Fluidmove Main Menu, select Configuration > Setup Fluid Manager.
 The Fluid Manager opens.
4. Click on the
Dot Weight Parameters tab.
5. Make sure
Control Dot Weight with Pressure is enabled. There should be a checkmark in
the box (Figure 7-52). If not, click on the box to enable it.
Figure 7-52 Fluid Manager – Dot Weight Parameters Tab
6. Click on the Air Pressure Settings tab.
7. Make sure that Valve, Fluid and Coax Cooling Pressure pressures are controlled by the
program. They should all be checked (Figure 7-53).
 NOTE The Coax Cooling pressure is used as the active air pressure.
8. Click
OK.