Owner's manual

7-62 Advanced Programming

To program dots using Dynamic Dispense Control:

 NOTE When programming dots, additional DDC settings are available through the Edit Dot

Parameters menu option.

1. Click

Teach a Program from the Main Window.

2. In the Programming Window, click on

Edit and select Edit Dot Parameters.

3. Click on the

Encoder-controlled Dots tab.

 The Dot Parameters screen (Figure 7-49) opens.

Figure 7-49 Encoder Controlled Dots

4. Make sure there is a checkmark in the Pos Ctrl On checkbox next to appropriate dot type.

If not, click on the box to turn this feature on.

5. Set the desired speed and acceleration.

 The percentage value is the percentage of the maximum motor speed. Higher values

result in faster motor speed. Lower values result in slower motor speed.

Valve On is entered in counts rather than in time. There are 38,000 counts per revolution.

 If this feature is not activated the speed, acceleration, deceleration, valve on, and

suckback options will be grayed-out (deactivated) and the default configuration settings

will be used.

 NOTE When Pos Ctrl is ON, the Valve On Time (sec) option on the During Dispense tab is

grayed-out (deactivated). See Figure 7-50 below.