Owner's manual

Advanced Programming 7-61
To program lines using Dynamic Dispense Control:
1. Lines are programmed the same way as before.
 Refer to Section 6 - Beginning Programming.
2. Set speed and acceleration by clicking
Configuration from the Main Menu and then clicking
Setup Valves.
3. Select the appropriate Valve and click on
Edit.
 The Valve Setting dialog box shown opens.
 The selections will vary depending upon the valve selected.
4. Click on the
Settings tab.
5. Set the desired speed and acceleration. See Figure 7-48.
 The percentage value is the percentage of the maximum motor speed. Higher values
result in faster motor speed. Lower values result in slower motor speed.
 Refer to 4.4.2 Valve Setup for additional information.
Figure 7-48 Setting Speed and Acceleration
6. Click on OK.
 NOTE Dynamic Dispense Control is not available on the DispenseJet Series Pumps.