Owner's manual

Advanced Programming 7-41
7.7.5 Defining the Module Definition Program
To define the Module Definition Pattern:
1. In the Programming Window, select
Edit > Edit Program Options > Select Module ID
Pattern
from the menu bar.
 The Select Module Definition Pattern dialog box (Figure 7-22) opens.
2. Click on the arrow
and select the desired pattern from the dropdown list.
3. Click
OK.
Figure 7-22 Selecting the Module Definition Pattern
7.7.6 Setting Up Locations
The Module Definition Pattern must have a defined pattern location for each module.
To set up locations and Module ID’s:
1. Open the Module Definition Pattern.
 If necessary, see 7.4 Editing a Pattern for instructions on opening a pattern.
2. In the Programming Window, select
Edit > Edit Pattern Locations.
 The Location Table dialog box (Figure 7-23) opens.
Figure 7-23 Location Table