Owner's manual

Advanced Programming 7-25
41. Select Reset Multipass Timer.
 This will start a new timer for the second underfill line.
42. Place the cursor on the second
END PASS and click on Time in the Program
Commands toolbar.
43. Select
Await Multipass Timer.
44. Type in
20 seconds and click on OK.
45. Place the cursor on
END PASS (for Pass 2).
46. Click on the
Dispensing Elements button on the Program Commands toolbar.
47. Click on
Weight Control Line .
48. Enter
30 mg in the Total Weight text box and select Type 1 for the Line Style.
49. Use the position controls to move the camera crosshairs to the ULHC of the first flip chip
model in the second row of flips chip models.
 Use Chip Offset or reticles.
50. Click on
Teach.
51. Use the position controls to move the camera crosshairs to the URHC of the same flip chip.
 Use Chip Offset or reticles.
52. Click on
Teach.
53. Click on
Done.
54. Click the
Timer button on the Program Commands toolbar.
55. Select
Reset Multipass Timer.
 This will start a new timer.
56. Place the cursor on the last
END PASS (for Pass 3) and click Timer on the Program
Commands toolbar.
57. Select
Await Multipass Timer.
58. Type in
20 seconds and click on OK.
59. Click the
Dispensing Elements button on the Program Commands toolbar.
60. Click on
Weight Control Line .
61. Enter
80 mg in the Total Weight text box and select Type 1 for the Line Style.
 This is the total weight to be dispensed at all the locations where this pattern will be
dispensed. In this case, three U-shaped lines around three flip chip models.
62. Use the position controls to move the camera crosshairs to the ULHC of the first flip chip
model in the second row.
 Use Chip Offset or reticles.