Owner's manual

3-2 Tour of Fluidmove
3.3 Starting/Exiting FmXP
The FmXP start-up procedure assumes that FmXP is already installed on your computer and that the
computer is turned ON and running Windows XP.
 NOTE If the computer on your system is not running Windows XP, consult Nordson
ASYMTEK Technical Support.
CAUTION! FmXP is designed for use on a dedicated PC. Using any other application while
FmXP is running may interfere with FmXP normal operation.
To start FmXP:
1. Open FmXP using one of the following methods:
 In the lower left-hand corner of your computer screen, click on Start > Programs >
FmXP >
.
 Double-click the FmXP icon
on the Windows XP desktop.
- When FmXP starts, it will check to see that all the Input and Output (I/O) devices
for your dispensing system are communicating properly with FmXP.
CAUTION! Do not press any keys or the mouse while FmXP is starting unless you are
prompted to do so.
2. When the FMXP Message 30416 - Dispenser Motor References Not Found appears, click
OK to Home the Dispenser (Figure 3-1). The FmXP Main Window will open.
Figure 3-1 FmXP Message 30416
 NOTE If you get any errors regarding the Conveyor, Dispenser, Heaters, or Vision System, refer
to the Troubleshooting section in the applicable dispensing system manual or contact a
trained service technician.