Owner's manual

7-16 Advanced Programming
17. Teach Fid 1 of the pattern Lfill at the same location as the origin.
 Make sure that the LLHC of the Quadrant Model in the area below the video display is
highlighted. If it is not, click on it to highlight it.
18. Click on
Teach.
19. Test Fid 1 or click on
Next.
 The Edit Window closes and the Edit Pattern Skip Info dialog box opens.
20. Select
Skip Pattern If Mark Not Found.
21. Click on
Teach Skip Mark.
 An Edit Window opens asking you to select the method for teaching your skip mark.
22. Select
Model Finder.
23. Click on
Next.
 Use the position controls to center the camera crosshairs on the dot slightly above and
to the left of where you taught the origin and fiducial.
24. Click on
Teach.
25. Test the skip mark or click on
Next.
 The Edit Window closes and you return to the Edit Pattern Skip Info dialog box.
26. Click on
OK.
27. Click the
Pattern button on the Program Commands toolbar.
28. Select
Pass Block.
 The Start Pass instruction dialog box opens.
 This is the command that allows you to reuse the fiducial and height sense information
for each pass, rather than perform the operation each time.
29. Enter
2 in the Number of passes text box.
30. Click on
OK.
 The program lines should appear as follows:
1 START PASS: FOR PASS 1
2 END PASS:
3 START PASS: FOR PASS 2
4 END PASS:
5 END
31. Place the cursor on the first END PASS.
32. From the Program Commands toolbar, click on
Dispensing Elements.
 An Edit Window opens.
33. From the Dispensing Elements toolbar, click on
Find Substrate Height.