Owner's manual

7-10 Advanced Programming
36. In the Available Patterns text box in the lower portion of the Edit Window, select WCLine1.
37. Use the position controls to center the camera crosshairs on the dot nearest the ULHC of the
first square in the top row on Side 2 of the Tutorial Board, the same dot used for teaching
the Origin of this pattern.
38. Click on
Teach.
 Use the position controls to center the camera crosshairs on the dot nearest the ULHC
of the second square in the top row on Side 2 of the Tutorial Board.
39. Click on
Teach.
40. Repeat Steps 36 -39 until you have placed the pattern on all of the squares in the top row.
41. Click on
Done.
42. Select
File > Save or click on the Save icon to save the program.
43. Enter
WCLine for the filename.
 The Workpiece Pattern should appear similar to the one in Figure 7-8.
 NOTE In Figure 7-8, (X
1
Y
1
) are the coordinates of the pattern starting point. Your program will
have numerical values.
Figure 7-8 Placing a Pattern
44. Select Run > Dry Run from the menu bar.
45. Watch to make sure that the program goes through the following steps:
 Locate Workpiece Fiducials.
 Locate Fiducials for each of the squares along the top row.
 Dry dispense L-shaped line around each square.