Owner's manual

Advanced Programming 7-9
25. Use the position controls to center the crosshairs on the URHC of the same square.
26. Click on
Teach to enter the second point of the weight control line.
27. Use the position controls to center the crosshairs on the LRHC of the same square.
28. Click on
Teach to enter the third point of the weight control line.
29. Click on
Done.
 A message box opens, indicating the calculated line speed for the newly created weight
control line.
30. Click
OK.
 You have defined an L-shaped line around the first square in the top row on Side 2 of
the Tutorial Board. Your program should appear similar to the one in Figure 7-7.
Figure 7-7 WCLine1 Pattern
 NOTE You are now ready to place the pattern. The WCLine1 pattern will be called from the
Workpiece pattern.
31. In the Programming Window, select
Workpiece from the Pattern Name text box.
 A message box opens indicating that the dispensing head is “About to move to
Reference Origin of Workpiece.”
32. Click
OK.
33. Click the
Dispensing Elements button on the Program Commands toolbar.
34. Click the
Pattern button on the Dispensing Elements toolbar.
35. Select
Place Pattern.