Owner's manual

Advanced Programming 7-7
Exercise 7-1: Creating and Placing a Pattern
1. Perform 5.4 Programming Setup.
2. Load Side 2 of the Tutorial Board and define workpiece alignment, origin, and fiducials.
3. Select
Teach a Program from the Main Menu.
 The Programming Window opens.
4. Select
File > New from the menu bar or click the Program Wizard icon to create a
new program.
5. Click on the
Pattern button on the Program Commands toolbar and select Create
Pattern.
 The Create Pattern dialog box opens.
6. In the Pattern Name textbox, type:
WCLine1.
7. Select
One fiducial.
8. Click
OK.
 An Edit Window opens asking you to teach the pattern origin.
9. Use the position controls to center the camera crosshairs on the dot nearest the ULHC of the
first square in the top row on Side 2 of the Tutorial Board. This will be the pattern origin for
WCLine1. See Figure 7-6.
Underfill Workpiece
Fluidmove for Windows Tutorial Board
Pattern With Skip Mark
ILLENNIUM
M
SERIES
Side 2
Underfill Workpiece
Fluidmove for Windows Tutorial Board
Pattern With Skip Mark
ILLENNIUM
M
SERIES
ILLENNIUM
M
SERIES
Side 2
Figure 7-6 FmXP Tutorial Board - Side 2
10. Click on Teach.
11. Click on
Done.
 The Edit Window changes asking you to select a method for defining a fiducial.
12. Select
Corner Finder and click on Next.
Pattern
Origin