Owner's manual

Beginning Programming 6-45
6.8.2.4 Editing Program Commands
To edit program commands:
1. Perform the steps outlined in 6.8.2.1 Opening a Program and Pattern.
2. Place the cursor on the line you wish to edit and double click.
 A Teach window opens.
3. Make desired changes and click
Done.
6.8.2.5 Editing Dot and Line Location
To edit dot location:
1. In the Main Window, click on
Teach a Program.
2. Open Program1.
3. Make sure the Workpiece pattern is selected. Refer to 6.8.2.1 Opening a Program and
Pattern.
4. Select
Edit > Edit Pattern from the menu bar.
5. Place the cursor on
1 DOT in the program and double-click.
 A Teach Window opens.
6. Use the position controls to move the camera crosshairs to upper right dot in the dots
pattern on the tutorial board.
7. Click on
Teach.
8. Click on
Done.
 The XY coordinates of your dot will change.
To edit line location:
1. In the Main Window, click on
Teach a Program.
2. Open
Program1.
3. Make sure the
Workpiece pattern is selected. Refer to 6.8.2.1 Opening a Program and
Pattern.
4. Select
Edit > Edit Pattern from the menu bar.
5. Place the cursor on
2 LINE in the program titled Program1 and double-click.
 A Teach Window opens.
6. Use the position controls to move the camera crosshairs to a new starting point on the first
line of the tutorial board.
7. Click on
Teach.
8. Use the position controls to move the camera crosshairs to the end point of the line.
9. Click on
Teach.
10. Click on
Done.
 The XY coordinates of your line will change.