Owner's manual

6-36 Beginning Programming
10. Click on Teach.
11. Use the position controls to move the camera crosshairs to the end of the line.
12. Click on
Teach.
13. Click on
Done.
 A message box opens, indicating the calculated line speed for the newly created weight
control line.
14. Click on
OK.
 The Workpiece Pattern program should appear as follows:
1 WEIGHT CONTROL: 20.000, 1,...
2 END
 20.000 is the weight of the line. “1” is the Line Style used for this line.
15. Repeat Steps 6 through 8 and type in
25 mg for the next line.
16. Use the position controls to move the camera crosshairs to the beginning of the next line on
the Tutorial Board.
17. Click on
Teach.
18. Use the position controls to move the camera crosshairs to the end of the line.
19. Click on
Teach.
20. Click on
Done.
 A message box opens, indicating the calculated line speed for the newly created weight
control line.
21. Click on
OK.
22. Repeat Steps 6 through 8 and type in
35 mg for the next line.
23. Use the position controls to move camera crosshairs to the beginning of the last line on the
Tutorial Board.
24. Click on
Teach.
25. Use the position controls to move the camera crosshairs to the end of the line.
26. Click on
Teach.
27. Click on
Done.
 A message box opens, indicating the calculated line speed for the newly created weight
control line.
28. Click on
OK.
29. In the Programming Window, select
Edit > Edit Line Parameters from menu bar to open
the Line Parameters dialog box.