Owner's manual

Beginning Programming 6-35
6.6.5 Editing Line Parameters
1. In the Main Window, click on Teach a Program.
2. In the Programming Window, click on
Edit and select Edit Line Parameters.
 A dialog box opens indicating the type of valve installed on your dispensing system and
which valve, Valve 1 or Valve 2, is currently active.
3. Click on
OK.
 The Line Parameters dialog box opens. See Figure 6-17.
4. To edit the line parameters, click on the desired tab and type the new value in the
appropriate text box.
5. Click on
Apply.
6. Click on
OK when done.
 The Line Parameters dialog box will close.
 NOTE When you edit line style parameters, it affects all lines in the program associated with
that style. If you just want to change parameters for one line in a program, you should
define a new style.
Exercise 6-3: Editing Line Parameters
1. Perform the Programming Setup routine as described in Section 5 - Programming Basics
and Setup.
2. Load Side 1 of the Tutorial Board.
3. In the Main Window, click on
Teach a Program.
 The Programming Window opens.
4. In the Programming Window, select
File > New or click on the Program Wizard icon.
5. Select
One fiducial and Teach Workpiece Origin.
 You will now be prompted to teach the workpiece origin and fiducials.
 NOTE Refer to Section 5 - Programming Basics and Setup for instructions on program
setup and defining workpiece alignment, origin, and fiducials.
6. Click the
Dispensing Elements button on the Program Commands toolbar.
 A Teach Window opens.
7. Click on
Weight Control Lines.
8. In the
Total Weight text box type: 20
 Entering
20 means that 20 mg of fluid will be dispensed along the length of the line you
will now define.
9. Use the position controls to move the camera crosshairs to the beginning of the top Basic
Line on Side 1 of the Tutorial Board.