Owner's manual

Beginning Programming 6-27
Dots.fmw
Workpiece
DOT: 1, (1.704, 10,064)
2 DOT: 1, (2.691, 10,064)
3 DOT: 1, (3,439, 10,064)
4 DOT: 1, (4.306, 10,064)
5 DOT: 1, (5,785, 10,064)
6 DOT: 1, (6.195, 10,064)
7 DOT: 2 (1.704, 5.341)
8 DOT: 2, (2.691, 5,341)
9 DOT: 2, (3,439, 5.341)
10 DOT: 2, (4.306, 5.341)
11 DOT: 2, (5,785, 5.341)
12 DOT: 2, (6.195, 5.341)
13 END:
1
Dots.fmw
Workpiece
DOT: 1, (1.704, 10,064)
2 DOT: 1, (2.691, 10,064)
3 DOT: 1, (3,439, 10,064)
4 DOT: 1, (4.306, 10,064)
5 DOT: 1, (5,785, 10,064)
6 DOT: 1, (6.195, 10,064)
7 DOT: 2 (1.704, 5.341)
8 DOT: 2, (2.691, 5,341)
9 DOT: 2, (3,439, 5.341)
10 DOT: 2, (4.306, 5.341)
11 DOT: 2, (5,785, 5.341)
12 DOT: 2, (6.195, 5.341)
13 END:
1
Figure 6-16 Dots Program – Workpiece Pattern
23. Select Run > Dry Run from the menu bar.
 The dispensing head will move after your response.
24. Watch to see the camera locate the position of the dots.
25. Select
Run > Wet Run from the menu bar.
 Watch to see the dots dispensed.
 You should notice a difference in the size of the Type 1 and Type 2 dots.
 Examine the board for quality and accuracy.