Owner's manual

6-18 Beginning Programming
To program a weight control line:
 NOTE A Flow Rate Calibration must be performed before Weight Control lines are
programmed. See 6.7.3 Measure Flow Rate Command.
1. Click on
Dispensing Elements on the Program Commands toolbar.
 A Teach Window opens.
2. Click on
Weight Control Line on the Dispensing Elements toolbar.
 Notice that the Teach Window has additional text boxes below the video display for
weight control lines. See Figure 6-10.
Figure 6-10 Programming Weight Control Lines
3. Type 20 mg in the Total Weight text box.
 Entering 20 mg means that 20 mg of fluid will be dispensed along the length of the line
you will now define.
4. Use the position controls to move the camera crosshairs to the beginning of the bottom
Basic Line on Side 1 of the Tutorial Board.
5. Click on
Teach.
6. Use the position controls to move the camera crosshairs to the end of the line.
7. Click on
Teach.
8. Click on
Done.
 A message box opens, indicating the calculated line speed for the newly created weight
control line.
9. Click on
OK.